Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-24-2002, 10:00 AM
|
#1 |
|
motors done......woohooo
Join Date: Mar 2002
Posts: 799
|
thats another thing, they said that the driveshaft would need to be lengthened about an inch, but my driveshaft only needs to be lengthened less than a quarter of an inch, so i dont know if i even need to. i have the stock driveshaft. i have heard that the frpp aluminum ones were about 1/2 longer than the stock ones, so i think im going to get one of those so i can have the right length shaft. (i dont know if thats true though)
1111111111111O111111111111----BELLHOUSING 1111111111O111111111111111----THROWOUT FORK HERES A LITTLE DRAWING OF HOW WELL IT LINES UP, I NEED TO HURRY AND FIGURE THIS OUT BEFORE I BREAK MY CABLE(AGAIN) |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tremec 3550, aluminum fly & clutch INSTALLED! | 302 LX Eric | Windsor Power | 3 | 10-01-2001 04:05 PM |
| Installing Tremec 3550 & King Cobra clutch - Any tips? | 302 LX Eric | Windsor Power | 1 | 09-05-2001 09:48 PM |
| Installing new Tremec 3550 - a few questions | 302 LX Eric | Windsor Power | 6 | 08-23-2001 03:04 PM |
| Longtubes w a Tremec 3550? | fastang | Windsor Power | 2 | 03-15-2001 07:43 PM |
| tremec 3550 swap | 97 Aztec | Modular Madness | 2 | 12-03-1999 09:12 PM |