Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-29-2002, 07:12 AM
|
#5 |
|
Registered Member
Join Date: Jul 2001
Location: West Bloomfield, MI
Posts: 391
|
im not sure what running without one will do (run rich or lean). but either of them isnt good for your motor. if you are really rich you will wash down the cylinder walls and premote wear as well as have bogging and iratic idle and hard starts. if its lean you can run into detonation which will destroy your motor.
hope it works out, adam
__________________
90 GT black/ grey leather ported GT-40 heads w/ 1.7RR, Cobra intake w/ ported lower, 24# injectors, 190LPH pump, 75mm Pro-M MAF, 65mm TB, K&N panel, BBK long tubes, Off road H-pipe, 2 ch. Flowmaster, Black magic fan, Kirban FPR, 180 deg. T-stat, 3.73's, Steeda Tri-Ax, 130 amp alt. Accell 8.8 race wires/cap/rotor, motorcraft plugs, Factory Five suspension, etc etc etc.... http://avbcon12.stangnet.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Surging Idle After MAF Install...HELP | Stang_Crazy | Windsor Power | 5 | 03-10-2002 09:49 PM |
| Surging idle makes the car die after new engine combo | dashapht | Windsor Power | 4 | 07-23-2001 09:56 AM |
| Idle problems & slight surging | Saleen308 | Windsor Power | 8 | 03-17-2001 07:21 PM |
| surging idle, code 34 | tomazzzo | Windsor Power | 3 | 03-17-2001 05:39 PM |
| After Pro-M 80mm & PIH kit (poor & surging idle) ??????? | HAITHAM | Windsor Power | 2 | 02-28-2001 07:17 PM |