Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-29-2002, 10:37 PM
|
#6 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
The problem isn't your cam, its the fact that you have it in an Sn95. Those computers do not addapt well at all to cams.
The B303 is NOT a bad cam by any means. I wasn't expecting much out of mine, but I am extremely impressed. In my car, it pulls very hard from 3000 all the way up to the rev limiter, and wants to go even further than that. If you are gonna slap a cam in an SN95, then you are gonna need a custom chip or EEC tuner if you want it to run decently.
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| E303 vacuum? | Nixon1 | Windsor Power | 17 | 07-16-2003 08:02 PM |
| 50 HP Cam Swap? Replace E303 with Comp XE270 | NO SLO PK | Windsor Power | 2 | 07-01-2003 04:52 PM |
| Grr, this e303 cam is frustrating in my 95stang | chickendreamer | Windsor Power | 5 | 04-10-2003 05:12 PM |
| e303 cam | drdo | Power Adders | 8 | 03-19-2003 03:06 PM |
| E303 with this setup | stng87 | Windsor Power | 3 | 03-14-2001 08:26 PM |