Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-30-2002, 02:09 AM
|
#3 |
|
Sober voice of Reason
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
|
Get a grinding stone to do the cutting and use a cartridge roll to finish it off. Whatever you do, make sure not to make the port into a "bell" shape at the end of the port, make sure to go back at least an inch or more. Also the straighter the better so if you're gonna re-shape the ports, take more off the short side because that is where the most airflow will be found. Good Luck.
P.S. I've been drinking tonight so if none of this makes sense then please disreguard 
__________________
393W: AFR 205's, hydraulic roller, TKO600. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| Questions about hoses connected to stock intake | zepherman | Windsor Power | 14 | 09-13-2002 05:05 AM |
| Porting a Trick Flow intake | Scrapla | Windsor Power | 4 | 09-04-2002 04:39 PM |
| does gt40 intake work with sn95? | daz95gt | Windsor Power | 8 | 01-13-2001 08:20 AM |
| Trophy Stock Intake Question? | RL Wiltshire | Racer's Club House | 7 | 10-20-1999 08:11 PM |