Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-30-2002, 01:42 PM
|
#6 |
|
Registered Member
Join Date: Oct 2000
Location: Charlotte NC
Posts: 193
|
I would say it could be inproperly adjusted valves also. Are they roller rockers or stock rocker arms. Also, until recently, I thought you should have a breather on one side of the motor also. But it was pointed out to me, that in a mildly beefed up or stock motor, that basically causes a vaccum leak at idle. Do away with breather if you have it, or take a hose from that hole back up to the air cleaner. Readjust the rockers using 1/2 to 3/4 turns after finger tight. Also. did you adjust them when both valves on that cylinder were completely closed? If not do so.
__________________
1969 fast back; yellow; weld wheels; 302 roller with GT-40 heads; 3:55 gears; 5spd T-5; MSD 6AL; E-303; flows; Hedman headers; Holley 600;Weiand Accelerator;1.6 rockers |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
| Please Help !! Engine Starting Problem | Jayskee | Windsor Power | 1 | 07-23-2002 06:08 PM |
| Engine shake problem? | chris91LX | Windsor Power | 1 | 05-19-2002 05:31 PM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |