Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-30-2002, 06:05 PM
|
#11 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
The last head to head article I saw was in a MM&FF magazine several years ago. The extrude honed stock intake did NOT outflow the Cobra. I'll have to dig up the article and double check.
100cfm out of extrude honing? I'd have to see it to believe it. Extrude honing doesn't take much material out. Just smooths out the casting. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Extrude hone intake | erl2589 | Windsor Power | 4 | 11-12-2003 03:43 PM |
| Extrude Hone Question | AntwaanRandleEL | Windsor Power | 4 | 03-20-2003 12:19 AM |
| Extrude Hone | Doctor DeBo | Windsor Power | 2 | 03-09-2001 09:33 PM |
| Extrude hone question | 84stang83zephyr | Windsor Power | 1 | 03-02-2001 08:07 PM |
| best price for extrude hone | 88workcar | Windsor Power | 3 | 01-15-2001 05:49 AM |