
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#4 |
|
Registered Member
Join Date: Nov 2001
Location: SanAntonio, Tx
Posts: 734
|
no, factory cable can Not be adjusted at the fork, it's weird how the haynes manual shows an adjustable one in their picture
anyway, does it feel sticky? mine looked burnt over bye where it comes out of the rubber, i had the, in traffic troubles too, ever since i installed my d&d quadrant the problem went away, but its weird because i still have to go almost all the way to the floor to shift still, but i have noticed in traffic, i dont have to sit there when the light goes green and wresle it in to 1st, i hated that , if you get a quadrant let us know, these guys helped me install mine, it looked a whole lot harder than it was...good luckbtw, i have the firewall adjuster and stilll havent experimented with it much, but i believe it will adjust further off the floor to your likeing.
__________________
Police package 5spd 90 Lx, Stock original motor, 3.27grs, BM fan, fms 10.5 clutch, D&D quadrant, and adjuster, ADS chip, 180 stat, mac cai, mac h-pipe, mac subframe connectors, ASP crank pulley, ripper shifter, 26x10.5 M/T sport pros welds. 246 hp according to analyzer ![]() Race weight: 3,120 E.t-13.57 with 26x10.50's e.t. streets. 1.88 60' mph- 99.92 mph |
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I just noticed my stupidity, I need a new clutch cable | 5.0 Fiend | Windsor Power | 3 | 09-20-2004 07:33 PM |
| Clutch cable Help! | NitroNixon | Windsor Power | 4 | 06-27-2003 01:58 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| Help with adjustable clutch cable | Rebel79 | Windsor Power | 6 | 04-20-2002 03:54 AM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |
