Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-04-2002, 11:16 AM
|
#7 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
I like the cold air BBK intake but i had to modify it a little to get it to fit on a 351 block since it's a little taller and wider. I basically just grinded down the tube coming off the fender and used a little muscle to get it to fit in the blue silicone connectors. Not too bad but I'd like something a little bigger, if possible. One thing's for sure, I'm not real fond of the C&L intake because it seems as if it just sucks in hot engine air rather than some fresh air from under the fender. Just my .02
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cold air intake for an 88 | StateTroopCoupe | Windsor Power | 4 | 10-19-2003 03:17 PM |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| Cold air intake (fender) | evilmustang | Windsor Power | 4 | 10-07-2001 05:03 PM |
| Cold Air Intake | trippinbillies40 | Small Ponies | 0 | 07-19-2001 03:47 PM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |