

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#5 |
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
![]() I would think that would be a pain, with all the interior pulled out but I guess it could be done. The MM piece is suppossed to be pretty nice also.
------------------ Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon! |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
I need a good 4 or 6 point roll bar. What's a good company? | tireburner163 | Blue Oval Lounge | 18 | 02-16-2003 01:36 PM |
What makes a weld job a quality weld job? | BlackFireN2O | Windsor Power | 19 | 09-02-2002 11:30 PM |
Questions on Roll Cages, Welding, and Ignition | BlackFireN2O | Windsor Power | 3 | 08-25-2002 08:01 AM |
Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
Roll cages? | Fox Body | Windsor Power | 4 | 08-16-2001 05:29 PM |