Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-06-2002, 05:27 PM
|
#6 |
|
Registered Member
Join Date: May 2002
Location: Portland, OR
Posts: 37
|
The fact that you spliced into the O2 sensors could be a problem. If your A/F meter draws any power, it will be messing up the voltage being sent to the computer. The computer ignors the O2 sensors and creates a rich condition under WOT, which might explain why the car runs OK when it's floored, but not in between. Did it have this driveability problem before the A/R meter was installed?
I would take out your A/F meter. Also, check the vac at the EGR valve. There is a solinoid that adusts the vac flow. If it's not working right, and allowing too much vacuum to the EGR, it will have the effect of leaning out. EGR flow is also turned off under WOT, I believe. Good Luck. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| will a 91 mass air harness work in a 88 gt? | bryan88gt | Windsor Power | 5 | 03-24-2002 12:39 AM |
| Anyone get ragged on at work for driving a Ford? | Crazy Horse GT | Blue Oval Lounge | 25 | 03-10-2002 07:26 PM |
| blow thru mass air meter? | PSI GUY | Windsor Power | 1 | 02-07-2002 09:16 AM |
| will this work for forced induction? | mikos chris | Windsor Power | 0 | 01-14-2001 03:05 PM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |