Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-06-2002, 08:59 PM
|
#5 |
|
Registered Member
Join Date: Mar 2001
Location: Gainsville,Fl
Posts: 229
|
T-5
well, we pulled out the T-5 and to our suprise, its clean as a whistle. BUT!, the input shaft is very very loose. It seems the front bearing is missing some shims and first gear is loose, the whole gear set is loos. They are all new and have no damage, synchros look brand new too. when we pulled the input shaft and first gear out, we inspected the roller bearings in it, they looked good, but will be replaced, only problem, a long( about 3/4" ) narrow roller(needle bearing I think) fell out and from where, I have no IDEA.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| So what kinds of things should I expect to start going wrong.... | Sicy Stang | Small Ponies | 2 | 10-24-2003 12:20 PM |
| Dyno'd today..Car running terribly lean | Grn92LX | Windsor Power | 0 | 06-21-2003 01:27 PM |
| Wrong dip stick, how much is too much? | jalangst | Windsor Power | 12 | 04-21-2003 05:53 PM |
| Wrong Balance - HOW Evident ????? | gp001 | Windsor Power | 2 | 02-28-2002 05:38 PM |
| Is This Wrong to do? | RedLilPony | Blue Oval Lounge | 15 | 05-02-2001 01:02 AM |