Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-02-2001, 12:41 PM
|
#4 |
|
Registered Member
Join Date: Mar 1999
Location: Largo, FL USA
Posts: 274
|
If the vibration increases with RPM and is not specific to a particular gear, or comes in at a specific RPM despite the gear, I would check the fan clutch. Mine went out at about 100k and caused the whole driveline and motor to shake. Too me a while to find it... just a suggestion.
------------------ 87 GT Full exhaust, K&N, KB Subs, BBK STB, homeade dumps... 87 Taurus New York Winters Bite! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aluminum Driveshaft | 96GTPRT | Modular Madness | 2 | 06-17-2002 11:58 AM |
| Ball Joints | gray ghost86 | Windsor Power | 4 | 06-06-2002 11:08 AM |
| separating ball joints and tie rod ends...best way? | 82 GT | Windsor Power | 8 | 02-22-2002 03:56 PM |
| Tremec in '95-Longer Driveshaft | 95Convert | Windsor Power | 1 | 07-22-2001 05:22 PM |
| Anybody using FMS Alum. Driveshaft? | Chris_H | Windsor Power | 6 | 01-05-2001 09:17 PM |