Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-22-2002, 06:02 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
Thanks Rick, I agree with you on the Throttle body.
The Holley is a great intake. I had it on my car before I re-did the engine. I made 242 RWHP with this combo: Holley systemax intake full length headers mac cat back electric fan So my engine was making 280-285 flywheel hp with just those mods. I was making 197 rwhp stock, so I picked up 45 hp with those mods. I also gained it throughout the whole rpm range.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| 306 street fighter from Coast High. short-block | yelowjaket | Windsor Power | 2 | 05-15-2003 06:02 PM |
| Fuel pressure at high altitude. etc... | Dark_5.0 | Windsor Power | 5 | 04-19-2002 07:52 AM |
| Cobra, Edlebrock, GT40, Mac, Explorer Intakes | Gautam | Windsor Power | 7 | 02-07-2001 10:37 PM |