Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-25-2002, 04:03 AM
|
#5 |
|
Registered Member
Join Date: May 1999
Location: Georgia
Posts: 3,866
|
just grind away the casting flash, and use 80 grit, you want it a little rough on a fuel injected upper. The dremel wont be the best tool to use, but might get you started. I did the same thing, and ended up buying a cheap air compressor and a air grinder.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| porting upper intake | 93SVTstang | Windsor Power | 1 | 03-13-2002 10:16 AM |
| Upper and Lower intake manifold | I hate Rice | Modular Madness | 5 | 08-30-2001 04:25 PM |
| Explorer upper....but what lower to use??? | 84LX89GT | Windsor Power | 2 | 08-13-2001 05:30 AM |
| REAR UPPER AND LOWER CONTROL ARMS | bcinyuz | Windsor Power | 1 | 05-08-2001 04:17 AM |
| Edelbrock Upper W/ Truck Lower?? | IMPULSERACING | Windsor Power | 2 | 04-16-2001 02:05 PM |