Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-27-2002, 06:30 PM
|
#28 |
|
Registered Member
Join Date: Jan 2001
Location: Live music capital of the world, TX
Posts: 324
|
while we're on the subject...
RPM427:
You made 326 rwhp with the stage 2 tfs cam and the systemax II? I assume you are running stock pistons... so I have a tick more compression, and am using the stage I and the TFS intake. What kind of power would you wager I am making? Also, on a slightly less related subject, My EGR stuff isn't fitting to well up to my intake because I have a kirbain billet fuel pressure regulator. The EGR plate comes about 1/8th of an inch from being flush to the intake. How can I remedy this problem? Can I just leave off the EGR plate altogether? Will I lose driveability, gas mileage? Once again this is on a TFS street intake.
__________________
96 Cobra - a bit too stock. 14.0 @ 101 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| 306 street fighter from Coast High. short-block | yelowjaket | Windsor Power | 2 | 05-15-2003 06:02 PM |
| Fuel pressure at high altitude. etc... | Dark_5.0 | Windsor Power | 5 | 04-19-2002 07:52 AM |
| Cobra, Edlebrock, GT40, Mac, Explorer Intakes | Gautam | Windsor Power | 7 | 02-07-2001 10:37 PM |