Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-01-2002, 05:34 PM
|
#1 |
|
Registered Member
Join Date: May 2001
Location: westerville, OH USA
Posts: 618
|
I was told by a machine shop that you don't need to use guideplates or aftermarket studs with aluminum roller rockers if the cam lift doesn't exceed .520
I got a set of proform roller rockers for a 355 sbc, my heads are still at the machine shop, should I have them machine and tap the heads for guideplates/studs or should I be ok?
__________________
1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pressure plate install, quick question | bmxmon | Classic Mustangs | 1 | 06-02-2004 03:44 PM |
| question, plz read | TwiLighTBluEGT | Windsor Power | 1 | 11-05-2002 04:01 PM |
| injector question please read | james87gt | Windsor Power | 1 | 10-12-2002 10:44 AM |
| TFS Guide Plate Alignment??? Thanks! | jseaton | Windsor Power | 0 | 11-04-2001 05:58 PM |
| Important Exhaust Question - Please Read | sublimelax | Small Ponies | 14 | 03-06-2001 10:14 PM |