Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-03-2002, 07:20 AM
|
#2 |
|
or '331 LX Eric'
Join Date: Jan 1999
Location: Columbus, Ohio
Posts: 2,142
|
I have the same headers. Here are my recommendations:
1) Take your time and try not to get frustrated. 2) Plan on jacking up the passenger side of the engine in order for the headers to drop in. 3) The bolts on the flanges don't always line-up perfectly. You'll have to start the bolts that do go in smoothly (keeping them loose) and then try to get the others to go in. On one flange, I had to use a bar to pry the flange over (just slightly). Then, I was able to get them all in. 4) Have fun! Good luck, E
__________________
1991 5.0 LX Coupe - 40,750 miles 331 cu. in. / Tremec 3550 / BFG Drag Radials 12.22 @ 114.31 mph - w/1.89 60' |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Shorty headers (equal length) | titanium92 | Windsor Power | 9 | 08-22-2004 09:18 PM |
| Full length or shorties? | Nicodemus | Small Ponies | 5 | 08-04-2002 10:55 AM |
| Equal or Unequal length shorties?? | SCOTTLT79 | Windsor Power | 2 | 07-28-2002 05:27 PM |
| BBK Equal Length Shorties - Install Question | Mac_5.0 | Windsor Power | 3 | 06-12-2002 07:50 AM |
| header gaskets for 86-93 BBK equal length shorties? | stanger8172 | Windsor Power | 5 | 10-11-2001 09:55 AM |