Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-04-2002, 08:23 AM
|
#4 |
|
Registered Member
Join Date: May 2000
Location: Kamloops, BC
Posts: 2,875
|
450 HP isn't enough for you eh, Hammer?
Ha Ha Ha. Well you've replaced every component on that car but the bottom end, so I guess it's your only concern. What's a bottom end rebuild cost? You know me, I don't know a whole lot about blowers, but knowing your luck I'd check the cost of a bottom end. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 68 Mustang Engine Swap pulley problems | kirkdickinson | Classic Mustangs | 10 | 07-13-2008 07:45 PM |
| QUICK: What belt size for 7in crank pulley with a 3.33in charger pulley? Vortech... | JaxMustang50 | Power Adders | 0 | 05-01-2003 06:44 PM |
| Need an altenator pulley??? | Coupe Devil | Windsor Power | 4 | 04-01-2003 09:06 AM |
| ? about a crank pulley!!!! | 90LXhatchback | Windsor Power | 3 | 02-21-2003 04:36 AM |
| Piggyback pulley problems! (long) | Mustang92 | Modular Madness | 3 | 01-16-2001 10:24 PM |