Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-11-2002, 05:56 PM
|
#7 |
|
Registered Member
Join Date: May 2001
Location: westerville, OH USA
Posts: 618
|
because when you bore it out .030 over, you make the entire bore slightly bigger in diameter. Basically, with a 302, if you filled the cylinders up with water, then measured the amount it took to fill all 8 of them, you'd have 302 cubic inches of water. When you take .030 off the cylinder walls, then measure it again, it turns out to be 306 cubic inches. Does this make sence?
__________________
1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stroked vs. Blown | gilmoujr | Modular Madness | 8 | 04-12-2004 12:45 AM |
| Bored, again. | bigwhitecobra | Blue Oval Lounge | 2 | 04-07-2004 03:32 PM |
| need some advice for people that have a fuel injected stroked 351 | Mustangboy89 | Windsor Power | 0 | 09-19-2002 11:34 PM |
| 302 bored | mustangman65_79 | Blue Oval Lounge | 3 | 06-30-2002 11:59 PM |
| Let's talk about gettin' STROKED! | 1HOTGT | Windsor Power | 4 | 04-27-2001 10:30 AM |