Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-22-2002, 03:28 PM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: Seattle, WA
Posts: 381
|
I think you can just take off the molding and it should be painted red under.
If you give your car a good polish, especially near the old location of the molding it should look fine. (Never done it, so can't be totally sure.) I was giong to do this when I got my front and back cobra spoilers. Thanks, DoranW
__________________
What I have: 1990 Red Mustang 5.0 LX: [BBK X-Pipe]-[MAC Cat-Back Exhaust] [MAC Cold Air Intake]-[BBK Equal Shorties] [3.55 Gears]-[Cobra Intake Manifold (Upper and Lower] [E-303 Cam]-[Granetelli Mass Air Flow Sensor] [Front and rear sway bars]-[New black carpet and seats.] [Adjustable Fuel Regulator]-[T5 Conversion w/ K. Cobra Clutch/Hurst STS] [Cobra Throttle Body]-[130A Alt. Conversion] Thinking about: Aftermarket Heads! Vortech A-Trim |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Body Molding Curling | KG88GT | Appearance & Detailing | 2 | 05-10-2004 04:46 PM |
| body side mouldings | gtsteve | Appearance & Detailing | 1 | 10-14-2002 05:55 PM |
| 87-93 LX 5.0 body molding | Bite the Bullitt | Blue Oval Lounge | 2 | 06-06-2001 02:04 PM |
| 87-93 LX 5.0 Side body molding - Will they fit my car | Bite the Bullitt | Windsor Power | 0 | 06-06-2001 12:27 PM |
| SIDE MOLDING ON SIDE WINDOW | 89FHPLX | Windsor Power | 6 | 01-06-2001 02:05 PM |