Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-24-2001, 08:08 PM
|
#8 |
|
Registered Member
Join Date: Jun 2000
Location: Richmond, VA
Posts: 78
|
There's a good wealth of information in the above posts. I'll spare repeating it all over again to you, but these guys are right in what they're telling you. I'm just now finishing up putting heads/cam/intake on my non-HO motor in my coupe. I've had some major problems getting the pulleys to fit right (crank pulley has a different offset than the HO's). Also, the fuel rails were different. The FPR was on the opposite side, so I've had to buy/fabricate new fuel rails. It's pretty much been a major PITA, but the final results should justify it all.
------------------ 1989 LX 5.0 Coupe 1992 LX 5.0 Convertible Moderator SN95.com, Stangtec.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| whats the difference?? | pedley | Windsor Power | 17 | 03-23-2004 05:17 PM |
| whats the difference between a 79-93 oil pan and a 94-95 oil pan?? | jruppert | Windsor Power | 1 | 03-26-2003 10:06 PM |
| 302 vs 302HO, difference?? | jerryIII | Windsor Power | 12 | 08-05-2001 03:11 AM |
| TFS O-Ringer vs. Non O-Ringed Heads. Whats The Difference? | BowTie Eater 5 Liter | Windsor Power | 3 | 02-08-2001 07:56 PM |