Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-25-2002, 11:07 PM
|
#3 |
|
Registered Member
Join Date: Jun 2002
Location: Portage
Posts: 239
|
When you hooked up the scanner did you hear any solenoids clicking? Ive had a problem with the connector being dirty and the scanner couldnt make a good enough of a conection to get the codes. Use some electrical cleaner or brake cleaner works to to spray the terminals with. let it dry and try it again. Hope this helps.
__________________
'95 GT convert. K&N, C&L mass air meter, Performance distributors sreamin demon coil, dyna mod, live wires, king cobra clutch, flowmaster american thunder exhaust, UPR billet adjustable shift handle, Crane Cams Fireball HI-6 box,underdrive pullies, 255lph fuel pump, UPr short throw shifter, caster camber plates, 03 cobra lower A arms, bullit suspension, cobra front brakes |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| O2 codes at open loop? | Nixon1 | Windsor Power | 6 | 04-24-2004 08:43 PM |
| KOEO & continuous memory codes?? | Simi Stang | Windsor Power | 4 | 12-16-2003 02:37 PM |
| Please Help: How to pull Codes? '94 V6 Drop Top... | Faded | Small Ponies | 1 | 08-12-2003 07:49 PM |
| Where do I put the jumper wire to pull codes on a 95 stang? | 93blkGTfun | Windsor Power | 3 | 05-12-2003 06:14 AM |
| Need to pull codes. | The Deuce | Blue Oval Lounge | 2 | 09-20-2002 07:49 AM |