Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-26-2002, 12:35 AM
|
#5 |
|
Registered Member
Join Date: Nov 2000
Location: Maple Ridge B.C. Canada, The Best Place In The World
Posts: 871
|
i am in the exact same boat as you. i started out with a K&N, i would never buy one again, i noticed no power.
remove the air silencer, set TPS to .98, if you run on good gas(91 or so) bump the timing, shifter(always helps the feel) cat back, h-pipe, and headers are usually a waste unless you have headwork. i also have an electric fan, and removed the smog pump.
__________________
1984 Bronco II, 36" Michelin Military Tires, 95 EFI 5.0, NP435 Tranny, NP208 Doubler, NP205 Transfer Case, Fill Size Solid Dana 44 Front End, WH Progressive Rate Rock Crawling Coils, Bronco 8.8 Rear, Skyjacker Softride Leafs, 5.13 Gears, Detroit Locker. Final Crawl Ratio Of 175:1 88 GT Best 60ft. 2.181 Best ET 14.350 Best MPH 98.01 ~WRECKED!!!!~ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about stock cam specs | MustangGT1990 | Windsor Power | 11 | 04-03-2002 10:04 AM |
| Good mods to start out on a 1988 F-150? | Vector | Built Ford Tough | 2 | 03-28-2002 06:36 PM |
| Pro-M on stock motor? | NotchJohnson | Windsor Power | 3 | 03-23-2002 10:28 PM |
| Is a Ported Stock Intake Worth It? | Stang_Crazy | Windsor Power | 9 | 09-28-2001 04:22 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |