Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-27-2002, 09:48 PM
|
#3 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
My clutch was doing the same thing before i swapped out the t-5 and replaced the clutch. Since the clutch has been replaced, the slack has gone away. Mine would be fine some times and others it would release and engage about 2 inches from the floor instead of the normal 5 or 6 inches from the floor as it does now. I'm gonna go ahead and say that your gonna need a new clutch sometime soon.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch pedal to high? | Scrapla | Windsor Power | 5 | 08-15-2004 12:16 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| 4cyl clutch pedal vs 5.0 pedal? | WADS56 | Windsor Power | 5 | 02-05-2002 02:27 AM |
| Clutch pedal and steering questions... | richd | Windsor Power | 2 | 12-19-2001 10:59 AM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |