Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-31-2002, 07:57 PM
|
#2 |
|
dude5l
Join Date: May 2001
Location: Grande Prairie, Alberta, Canada
Posts: 603
|
I'm not sure if that tranny will bolt up to a 5.0 without changing the input shaft, I know the 4 cyl. trannys were different, not sure about the V-6's though. As for a governor, I assume your talking about a rev limiter, which is part of the EEC (computer) which I would think you will have to change as well.
__________________
Good luck! Brad R. 1992 L.X. 5.0 coupe MODS: A few little bolt ons  New Best time ...11.60 @ 128 mph @ 2000+ ft altitude. Rice Haters Club member #39 Users rides #2542 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch Release lever Spring Question | orlowted | Classic Mustangs | 2 | 12-22-2003 06:32 PM |
| Clutch wont hold no more? question.. | Coupe50h | Windsor Power | 10 | 07-18-2003 03:50 AM |
| Hi! Newbiew w/ a 5.0 flywheel clutch question! | Beanhead | Windsor Power | 10 | 11-01-2002 07:15 PM |
| Clutch question/ in ref. to my last post | Oldschoolpony | Windsor Power | 0 | 05-17-2002 12:00 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |