Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-03-2002, 09:20 PM
|
#4 |
|
Registered Member
Join Date: Jul 2002
Location: belle chasse La.
Posts: 47
|
Measure from the rear seal on the tail shaft to the pinion on the rear end, then measure the drive shaft from the yoke that bolts to the rear end and put a mark using your first measurement,it should be 3/4 to 1 inch past the tapered part of the input shaft on the front of the drive shaft.
__________________
DSS306 SHORTBLOCK,STAGE2 VICTOR JR. HEADS,AEROMOTIVE FUEL SYSTEM,TFS INTAKE,50# INJECTORS,MSD6AL,D-1 PROCHARGER,TKO TRANS.,CENTERFORCE CLUTCH,MAC LONGTUBE HEADERS,FLOWMASTERS,OFF-ROAD H-PIPE,3.73 GEARS, 6 POINT ROLL CAGE, ALL IN A 1995 GTS |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driveshaft or Rear-end | UglyFast88 | Windsor Power | 3 | 06-04-2003 07:16 PM |
| Cam or Driveshaft???? | bigred90gt | Windsor Power | 2 | 11-21-2002 02:05 AM |
| Aluminum Driveshaft getting scraped on acceleration... 1994 GT Parking brake Recall?? | NYC1 | Windsor Power | 5 | 11-17-2002 01:15 PM |
| Tremec in '95-Longer Driveshaft | 95Convert | Windsor Power | 1 | 07-22-2001 05:22 PM |
| Aluminum Driveshaft...Balance? | chris91LX | Windsor Power | 4 | 02-10-2001 12:43 PM |