Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-07-2002, 11:04 AM
|
#3 |
|
Registered Member
Join Date: May 2000
Location: Kamloops, BC
Posts: 2,875
|
I'm not sure on a 4.6L. But don't get disilluioned about the adjustability of a TPS. You don't just turn a screw or somthing to adjust them. You have to bore out the screw holes and physically move the whole TPS housing to change it's setting. It is not that easy.
Basically you should be .90 to .99 Volts on your TPS as long as you are in that range (at idle) you're fine (4.6 or 5.0). |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| adjusting valves/ stud mount?? PKRWUD? Anyone?? | Simi Stang | Windsor Power | 8 | 07-08-2003 11:43 AM |
| I got a free mass air sensor | stevstum | Windsor Power | 2 | 05-27-2003 12:50 PM |
| Whats the best way to tell if your running lean or rich? | K.C. 5.0 | Windsor Power | 9 | 09-10-2001 03:04 PM |
| Sensor on Top of T5? | Green92LX | Windsor Power | 13 | 07-29-2001 10:11 PM |
| Temp sensor question | RB92GT | Windsor Power | 2 | 06-23-2001 12:23 PM |