Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-09-2002, 03:48 PM
|
#4 |
|
Registered Member
Join Date: Jul 2002
Location: Pont Rouge, Quebec, Canada
Posts: 45
|
Buy an old (used) E7TE head.
Cut the head in straight line over the center of the intake and exhaust valves. You ll know exactly where and how thick you can remove the material. I did 12.723 @ 105.93 mph with stock ported head. Regards, |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| intake porting and polishing? | eeh1025 | Windsor Power | 1 | 03-12-2004 09:00 AM |
| Is the stock intake a bottleneck for a street only setup? | Fox Hound | Windsor Power | 6 | 01-03-2003 03:30 PM |
| Questions about hoses connected to stock intake | zepherman | Windsor Power | 14 | 09-13-2002 05:05 AM |
| Porting a Trick Flow intake | Scrapla | Windsor Power | 4 | 09-04-2002 04:39 PM |
| Ported Stock Intake HP??? | BowTie Eater 5 Liter | Windsor Power | 13 | 03-22-2001 01:07 AM |