Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-10-2002, 12:59 AM
|
#2 |
|
Registered Member
Join Date: May 1999
Location: Blacksburg, VA
Posts: 1,526
|
Look at the arm for the tie-rod. The 96+'s have a straight arm while the 94-95's have a bent arm. The 96+ will also make for a +8mm track width per side. Here's a picture of the difference:
http://www.corner-carvers.com/forums...=&postid=28925 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 302 engine identification | ponydude | Classic Mustangs | 10 | 09-19-2010 08:34 PM |
| Adjustment nut on spindle - what ft/lbs? | 302 LX Eric | Windsor Power | 2 | 04-17-2003 09:49 PM |
| Spindle Identification | JohnnyG | Windsor Power | 0 | 08-08-2002 10:00 AM |
| spindle mounted rims? | WADS56 | Windsor Power | 1 | 08-07-2002 06:53 AM |
| Motorcraft/Holley carb Identification | agazzo | Windsor Power | 1 | 03-31-2001 07:38 PM |