Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-17-2002, 10:56 AM
|
#4 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
I'm 90% sure it's the coil.
Disconnect the wires from the coil. Set a DMM to ohms, and measure the resistance across the primary terminals (small + & -). It should be between .3 and 1.0 ohms. Next, measure between the primary neg terminal (small -) and the secondary terminal (where the coil wire from the distributor goes). It should be between 8 and 11.5 k-ohms. If it fails either test, replace the coil. Take care, ~Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TFI module vs Ignition module | teallighting | Windsor Power | 1 | 03-21-2004 03:38 AM |
| Best Ignition module and Coil? | 88fivepointoh | Windsor Power | 2 | 03-02-2003 01:23 PM |
| Fuel pump, Ignition module or something else? | MattwantsSpeed | Windsor Power | 16 | 07-07-2002 08:38 PM |
| Best place to mount an ignition module? | Blue Beast | Windsor Power | 4 | 03-16-2002 01:19 PM |
| Ignition Module | mustangLX92 | Windsor Power | 3 | 07-05-2001 05:18 AM |