Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-22-2002, 10:50 AM
|
#3 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
I unbolted the mounts and I was able to get one side on. How far do you tighten the bolts? The bushings compress alot when you tighten thme down. I think I will try the floor jack idea. I'm not sure if it will reach, I have it high enough so I can get the tranny out (I'm doing my clutch). Thanks.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sway bar or no sway bar? | chris91LX | Windsor Power | 4 | 08-22-2002 11:11 AM |
| rear sway bar replacement | wade73 | Modular Madness | 8 | 05-07-2002 06:37 PM |
| Any one with a sway bar? | Rocket 99GT | Windsor Power | 1 | 03-23-2001 04:23 PM |
| Steeda rear sway bar | Rocket 99GT | Modular Madness | 1 | 03-13-2001 12:41 PM |
| Should I buy (used) Front Sway Bar? | Gautam | Windsor Power | 6 | 01-29-2001 09:34 PM |