help T-5 experts? shifter a bad choice??

Rick 91GT · 05-31-2001, 07:35 AM

If it whines and sounds like a supercharger on acceleration and deceleration, I will bet it is the imput shaft getting ready to let go. Although you may get away with it for a while it will fail. As for parts to do the rebuild correctly, new imput shaft, contershaft, 2nd and 3rd gears, and the rebuild kit will run $550. I could rebuild it but the shipping would probably kill you from TX to PA. I would call D&D or Hanlon for the parts, either should have them in stock. The aftermarket shifter will increase the road noice heard through the shifter because it is a soild nice piece not the flimsy poor excuse for a shifter that the stock one is. If it were the syncros it should grind or pop in or out of gear or sometimes not want to go into gear, 2nd gear has trangle shaped ares to allow the gears to slide in, it is famous for getting flat when power shifting. The reaseon you only here it in 1st-3rd is 4th gear is a direct drive and has a lot of load on the tranny so it is there but is harder to hear it.

------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
shifter cable question	82 GT	Windsor Power	3	05-25-2004 10:03 PM
No Need for Aftermarket Shifter after this Mod !!	Katmandu	Windsor Power	6	03-24-2004 06:07 PM
what would you ask for for christmas??	lx5091	Windsor Power	28	11-22-2002 10:52 AM
Pro 5.0 Shifter problem	TomEboi	Modular Madness	1	05-26-2002 09:18 PM
Mac shifter install questions	Chevyguy	Windsor Power	5	10-22-2001 03:01 PM

05-31-2001, 07:35 AM	#1
Rick 91GT Procharged! Join Date: May 1999 Location: Hanover, PA Posts: 1,539	If it whines and sounds like a supercharger on acceleration and deceleration, I will bet it is the imput shaft getting ready to let go. Although you may get away with it for a while it will fail. As for parts to do the rebuild correctly, new imput shaft, contershaft, 2nd and 3rd gears, and the rebuild kit will run $550. I could rebuild it but the shipping would probably kill you from TX to PA. I would call D&D or Hanlon for the parts, either should have them in stock. The aftermarket shifter will increase the road noice heard through the shifter because it is a soild nice piece not the flimsy poor excuse for a shifter that the stock one is. If it were the syncros it should grind or pop in or out of gear or sometimes not want to go into gear, 2nd gear has trangle shaped ares to allow the gears to slide in, it is famous for getting flat when power shifting. The reaseon you only here it in 1st-3rd is 4th gear is a direct drive and has a lot of load on the tranny so it is there but is harder to hear it. ------------------ Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!