Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-23-2002, 08:32 AM
|
#16 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Since the water pump was brought up, is there any flow difference between the Edelbrock and the FRPP? I have the Griffin 31X19 aluminum, Mark VIII fan, 180 Hi-flow thermostat and 2 bottles of water wetter with all water and still run 180-195 without a/c in no traffic.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Couple of quick, stupid questions! | SCOTTLT79 | Windsor Power | 4 | 02-15-2003 04:02 PM |
| Couple of Questions | beach | Blue Oval Lounge | 2 | 04-06-2002 11:33 AM |
| Couple of Questions | FrankenStang | Stang Stories | 1 | 02-23-2002 12:47 AM |
| Couple Questions | StoplightWarrior | Modular Madness | 5 | 11-25-2001 11:52 PM |
| Have a couple of questions... | physicusstang | Windsor Power | 2 | 08-28-2001 09:27 PM |