
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
|
|
#1 |
|
Guest
Posts: n/a
|
-use the 1.7 roller rockers (best bolt on when I still had stock heads) they are less than 180 dollars new from summit
-get 3.55's, I have seen better 60 ft's over 3.73's -get anal with weight in car, lose spare tire, passenger seat, etc -throw your timing to 13-15 advanced with 92 octane -launch the car a lil higher in rpm and ride the clutch if necessary -you may not like this but powershift from 2nd to 3rd to 4th..it will help. -a aftermarket mass air meter will add 10-15 horsepower also depending on what air inlet set up you have. in my 92 hatch last year...it went 14.6@99mph..with AOD, full length headers, 1.7 roller rockers and 3.55's and that was all it had on the stock motor...and off road pipe off course. |
|
![]() |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help me make this 88 gt handle better | RoushRacing6N17 | Windsor Power | 3 | 11-20-2003 09:43 AM |
| Replacing convertible top. How hard is it? | Dark_5.0 | Windsor Power | 7 | 06-09-2001 09:01 PM |
| 87-93 Convertible Question | SmokeyDP | Windsor Power | 1 | 05-11-2001 12:48 PM |
| convertible top rattles | cleangreenmachine | Windsor Power | 1 | 01-13-2001 09:16 PM |
| Inside Convertible Top | SmokeyDP | Windsor Power | 4 | 01-01-2001 10:46 PM |
