Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-29-2002, 10:28 PM
|
#3 |
|
Registered Member
Join Date: Jun 1999
Location: Columbia Co, PA
Posts: 303
|
I'm on my 2nd Pro 5.0. One for my T5 and one for my3550.
I was going to try a Triax just for the fun of it. But then I ordered some other parts from Steeda and had a very bad experience with them and a lot of run around. Now I'll never have anything else from Steeda in my car unless it's free. I know the B&M has different spring strengths for adjusting the return to neutral force. I wish I could stiffen up the springs in my Pro 5.0 a little bit. Make the 2-3 power shift go a little better I think. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| No Need for Aftermarket Shifter after this Mod !! | Katmandu | Windsor Power | 6 | 03-24-2004 06:07 PM |
| Need correct linkage from AT shifter to C6 | 69coupe | Classic Mustangs | 0 | 12-16-2002 10:25 PM |
| what would you ask for for christmas?? | lx5091 | Windsor Power | 28 | 11-22-2002 10:52 AM |
| Pro 5.0 Shifter problem | TomEboi | Modular Madness | 1 | 05-26-2002 09:18 PM |
| Mac shifter install questions | Chevyguy | Windsor Power | 5 | 10-22-2001 03:01 PM |