Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-31-2002, 04:51 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
Right now I think i have the stock injectors. I bought the car used and assumed they were stock since everything else was. There kinda orange in color. I'll try the CnL mass air with a piece of cardboard in there to stop the fan wash and see if it helps at all. But its an electric fan so any problems i see would happen all the time, not just when the rpms are up. Fuel pressure is just over 34 lbs, timing is advanced as far as it can be without pinging. I'm not sure what that is cuz i don't have a timing light. I'de assume somewhere between 14 and 18 degrees.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Full dyno testing on the C&L Plenum, 75mm TB, C&L MAF | 91LX2Bfast | Modular Madness | 4 | 01-23-2004 07:09 PM |
| cobra?? IMRC/ injectors and C&L | mellow98cobra | Modular Madness | 1 | 07-18-2003 11:18 AM |
| Should I add a cold air system to the C&l meter? | v8thunder | Modular Madness | 5 | 06-23-2003 01:40 PM |
| C&L Clear sampling tube? | Falcons Talon | Windsor Power | 2 | 05-08-2003 08:14 AM |
| C&L install | OMAR | Windsor Power | 0 | 04-22-2003 11:32 PM |