

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
NX dealer-man
Join Date: Sep 1998
Location: Peoria, Illinois
Posts: 977
|
![]() LOL!!!!! (that's a good one) ...sick, very sick, but funny!
Practice!!!! ...that will produce the best results! Get some scrap metal and start doing butt-joint welds, T-joint welds, and lap-joint welds, vertical, horizontal, over head, etc. I'm not well versed in the technical jargon of welding, but I can pick up a MIG, set it up properly, and lay down a good bead... I forgot all the technical stuff I learned in high-school welding class, but I work in a muffler shop and use a MIG there and have a small MIG at home that gets used occasionally... I'd never attempt a rollcage unless I had a TIG welder, ... but I've installed subframe connectors for several people at the shop before without any complaints or problems, I installed my anti-roll bar and did all the welding on my torque boxes... so I've got the hang of things ![]() So my novice advise to you would be to take a welding class at a local community college or get the book that was mentioned and start practicing!!!! ![]() |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
weld an intake??? | whitepony | Windsor Power | 12 | 04-17-2004 03:10 PM |
Quality of Life and the struggle. | Mercury | Blue Oval Lounge | 17 | 09-04-2002 12:39 PM |
WELD WHEEL QUESTION on backspacing- your advice | Spenc2u | Windsor Power | 0 | 01-16-2002 03:23 PM |
Weld Draglites (what's next) | TJR | Blue Oval Lounge | 2 | 06-10-2001 09:12 PM |
Need some input regarding Weld wheels | Ares | Modular Madness | 3 | 03-05-2001 08:59 PM |