Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-07-2001, 09:38 PM
|
#5 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
I am getting the 347 kit that excessive motorsports sells because they screwed up one of my orders really bad so they are giving me a really good deal on the kit; better than I could find anywhere else.
The kit comes with a 5140 steel crank and 4340 H-beam rods, ect. What is the difference between 5140 and 4340 steel? I will be running canfields heads with race port work and a performer rpm intake and a 750 carb. Do you think I should run a victor jr. intake or the performer rpm intake? I will only be turning it to about 6000 rpm. My compression will be 10.9-1. ------------------ James Cox nochevy@hotmail.com 1991 Mustang LX 12.565 @109.38mph 1.764 60ft |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a stroker motor | Mustang_289 | Windsor Power | 4 | 02-17-2005 12:46 PM |
| Blown Stroker Computer Help | RabidPony | Modular Madness | 10 | 02-07-2004 11:56 PM |
| 'super' stroker vs 'budget' stroker | mike5p01 | Windsor Power | 4 | 10-11-2003 10:11 PM |
| Decided to build a stroker, but where do I start? | WhiteLX | Windsor Power | 5 | 12-16-2002 10:35 AM |
| stroker engine question | 82 GT | Windsor Power | 1 | 06-08-2001 03:22 PM |