

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#5 |
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
![]() wow, I really need to get that done then.
I was at the track today and almost smacked the wall a few times and had to let out of it completely on 2 runs. One was my best 60ft ever too (1.63) ![]() Pressure in my 26x10 hooiser slicks was 13.5psi and it was really wobbly about 400ft and after, then I air'd them up to 17 and it was better, but still felt unsafe. Do you think it'll fix most of my problem to if I re-inforce them? I've already got MAC upper and lower control arms, so that part's done. I noticed that my car started swaying in the rear awhile ago, and then I realized it started after I swapped to a T-5 and started launching hard on slicks. I musta ripped those puppies pretty bad.
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clutch hard to push in?????? | 5ohCOUPE | Windsor Power | 11 | 03-07-2003 06:55 AM |
on board hard drives | hobgoblin351 | Audio, Security, & Electronics | 4 | 11-21-2002 09:48 PM |
tremec hard as hell to shift | rob90gt | Windsor Power | 16 | 03-15-2002 02:33 PM |
Smell under hard acceleration | elma22 | Windsor Power | 7 | 09-10-2001 03:39 PM |
Replacing convertible top. How hard is it? | Dark_5.0 | Windsor Power | 7 | 06-09-2001 09:01 PM |