Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-01-2002, 07:40 AM
|
#4 |
|
Registered Member
Join Date: Aug 2002
Location: Rochester
Posts: 553
|
Question for you Drastik.. I pulled my distrubutor this morning and I was looking at my Gear, and the bottom of it, and i see serious heat marks, also When i pulled the distributor shaft apart, I noticed the little flat bearing was digging into the distributor case itself.. Could the entire distributor housing be bad and causing serious friction therefore buring up my TFI's? My distributor gear doesn't look so good... Its a freash cam in there i hope it didn't cause damage to it.. I have the F303 Cam..
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TFI module vs Ignition module | teallighting | Windsor Power | 1 | 03-21-2004 03:38 AM |
| Another TFI Module Failure | NO SLO PK | Windsor Power | 5 | 12-24-2003 11:39 AM |
| Fuel Problems...I think | silver_pilate | Windsor Power | 15 | 05-31-2003 08:36 PM |
| Fuel Pump or TFI Module ??? | mimicons | Windsor Power | 1 | 05-13-2003 02:35 AM |
| TFI Module Problems | Tony91LX | Windsor Power | 1 | 08-30-2001 04:29 PM |