

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#14 |
The Photoshop Guru
Join Date: Feb 2001
Location: Mecca, Indiana
Posts: 1,419
|
![]() Rick is right. It's all about traction. That was my main problem last time out and it really hurt my times which you see in my sig. I should be able to hit 12's with my engine setup, but I kinda went about my mods bass ackwards not starting with the suspension, but I really haven't added much stuff that wasn't needed. Almost everything I have added has been to replace a stock worn out part so I figured while I'm replacing this, I might as well do that, etc.
South Side lift bars help a ton. I have a buddy with them and his car will stick you in the seat from a good high RPM launch. Just remember... there's always a weak link. Once you get the car able to launch at 5000rpm without spinning halfway down the track you can bet your @ss something else is going to go. Whether it's the tranny, driveshaft, axles, or whatever. So be prepared. Good luck! ------------------ Too much to list. Best ET on the car so far with stock 2.73 gears - 13.73@102mph Indiana Stangers Association Buy your parts here ICQ# 42269241 |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
engine swap | Snakebite427 | Small Ponies | 2 | 10-19-2001 08:17 AM |
Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Small Ponies | 0 | 05-12-1999 02:27 AM |
Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |