Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-03-2002, 05:40 PM
|
#6 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
If you dont have the shim and just torqued your rockers down, they would be putting too much pressure on the valve, and its possible that they aren't letting the valve fully close, resulting in crappy performance.
Put a 0.025" shim under the rocker, and tighten the bolt down until you can no longer spin the pushrod freely, then if the shim is correct, you will come to your torque spec between 1/4-3/4 of a turn. good luck
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
|
|