Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-06-2002, 09:26 PM
|
#15 |
|
Registered Member
Join Date: Oct 1998
Location: Az
Posts: 854
|
just a little FYI....if you're using a 79 dist in a roller cammed car...the dizzy gear will last a few hours.... the steel cam will chew the cast iron gear up...you need the gear off an 85 dist...or a replacement steel one.... :-)
unless you changed it already... then never mind :-D
__________________
84 convt,roller 302,AFR's, performer 3.55's, underdrives BBK shorties stock cam, 1.7's 13.58@102.84 and a '68 stang .. project 8 sec street car... 557 big block + N20 :-) http://members.cox.net/darkknight302/68nwrear.jpg |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carb to FI conversion | SlowMopar | Windsor Power | 5 | 04-11-2004 04:29 PM |
| Timing issues | SmokinStangGT | Windsor Power | 5 | 05-21-2003 12:17 PM |
| Throttle body to carb conversion | Budiak | Classic Mustangs | 3 | 07-02-2002 02:04 AM |
| anyone did a carb conversion and still used stock ignition system???? | vande97 | Windsor Power | 6 | 04-25-2002 10:17 AM |
| Timing a carb motor? | Coupe Devil | Windsor Power | 7 | 07-27-2001 12:10 AM |