Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-07-2002, 08:10 PM
|
#24 |
|
Registered Member
Join Date: Oct 2001
Location: Madelia,MN USA
Posts: 58
|
B-cam good choice
I had a B-cam in my 90gt raced it a lot. I had no problems with Idle/driveability. Ford makes simple dependable cams that work well to make good power. There maybe different cams out there that make more power per combo but I think the ford cams accept alot of different combo's and work well with them all. The B-cam had a rough Idle and in my car made most of it's power 3,500+. I have read alot of posts on this site were people had surgeing idles with the E-cam but I think that was mostly due to speed density in the older mustangs. You will sure notice the power difference over the stock cam.
__________________
331 stroker, JE 8.5:1 pistons, H-beam rods, steel crank, main cap, msd with 3step, BBK ceramic long tubes,TKO, 4.30's, motorsport Z303, Victor Jr aluminum heads, crane gold 1.6, southside lift bars, 90/10 front, 50/50 rear, centerforce dual friction clutch, Vortech S-trim soon. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Optima battery selection | PWR_RYD93 | Windsor Power | 12 | 01-12-2004 01:09 PM |
| Intake selection with a 383/408 stroker | Capri306 | Windsor Power | 12 | 05-03-2002 10:12 PM |
| Gear Ratio Selection | Green96GT | Modular Madness | 4 | 07-19-2001 11:40 AM |
| wheel and tire selection | Danielz9 | Corner Carvers Delight | 1 | 05-04-2000 08:38 AM |
| Gear selection | Grulla | Corner Carvers Delight | 1 | 03-13-2000 09:04 AM |