Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-10-2002, 03:26 PM
|
#1 |
|
Registered Member
Join Date: Apr 1999
Location: greenwood, ar
Posts: 118
|
I have used the greese before. It's a lil messy but it does work. I think I used a large bolt and a lil tape to get the exact size right. came out fairly easy. I had a tool but it didn't work very well because it was just the outter race of the bearing left in there. the rollers and the center completely failed and were in peices. I think the previous owner tightened the bolts on the trans. down and made it fit instead of lining it up correctly. I could also see the soap working and not be quite as messy. Either way Good Luck!!
__________________
'89 GT K&N, Twisted Wedge heads, TFS intake,FMS 1.7 rockers, Trick Flow stage 1 cam(221*/225* .530in\.542in) , 3.73's, headers, off road H-pipe, Flowmasters, FMS Clutch, Tremec, PRO-5.0, FMS driveshaft, fluidyne alum. radiator, and more to come. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Does the T-5 pilot bearing need to come out for an AOD to go in? | crazypete | Windsor Power | 14 | 11-06-2003 11:04 PM |
| Pilot Bearing | Cody2552 | Windsor Power | 2 | 04-09-2003 09:30 AM |
| Pilot bearing replacement | Rebel79 | Windsor Power | 8 | 05-31-2002 02:12 PM |
| roller pilot bearing part # | Strim91GT | Windsor Power | 0 | 04-23-2001 02:12 PM |
| Need help getting pilot bearing out of crankshaft... | TROYXTROY | Windsor Power | 7 | 01-22-2001 04:25 PM |