Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-11-2002, 10:59 PM
|
#12 |
|
Registered Member
Join Date: Mar 1999
Location: Amarillo, Texas, USA
Posts: 780
|
I just did this not too long ago. Go to someplace like Harbor Freight and look into a slide hammer kit. It has these neat little expander plugs that will fit into the hole very nicely. They expand outward enough to slam the thing out. It's in there real good but with a minimum of patience it should pop right out.
And yes, I'm still alive. . . a lot older now but still alive.
__________________
1986 four-eyed LX coupe, 358 Cleveland, Tremec TKO600/centerforce clutch, dish cut Probe forged pistons, comp cams hyd.roller cam, .579/.588@224/230, Edel.performer, 670 holley street avenger, CPR custom built long tubes, ported and polished 4bbl heads, manley valves, beehive springs, MSD peo-billet dist/MSD6AL, fluidamper, 5 lug conv. with 17x8 bullits there's more but it's still not finished yet. Oh, and the oldest boy is turning his 89 GT into a FFR cobra this next summer. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Does the T-5 pilot bearing need to come out for an AOD to go in? | crazypete | Windsor Power | 14 | 11-06-2003 11:04 PM |
| Pilot Bearing | Cody2552 | Windsor Power | 2 | 04-09-2003 09:30 AM |
| Pilot bearing replacement | Rebel79 | Windsor Power | 8 | 05-31-2002 02:12 PM |
| roller pilot bearing part # | Strim91GT | Windsor Power | 0 | 04-23-2001 02:12 PM |
| Need help getting pilot bearing out of crankshaft... | TROYXTROY | Windsor Power | 7 | 01-22-2001 04:25 PM |