MAF ???'s

jruppert · 10-13-2002, 01:16 PM

I have a question in relation to the topic. I have a '94 GT with similar mods as the first guy. GT-40P heads (ported and polished), e-303 cam, edelbrock upper and lower, 70mm tbody, 77mm pro-m, 24lb injecters, tremec tko, 3.73 gears, and recently added underdrive pullies. Anyway, not too long ago my Pro-M took a dump on me. It started making the cats run extremely hot and started smoking. I ran codes and said that my MAF was running below expected min. voltage. I sent the MAF back to have them take a look at it and possible recal. At the time I bought this MAF I didnt realize that you could use the C&L and change the sample tube. So what do u guys think?? If Pro-M comes back and says that I need to replace the sensor at my cost should I do so or should I just invest in a C&L with the sample tube for 24lb. Pro-M claims that if its their fault, they will take care of it. Now I know they claim this but you know how it is, its never their fault. I am not sure what they will charge for the repair but from what I understand you can buy a new C&L for $190 or so. Let me know what you guys think.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
04 Gt ???S	04S/CStallion	Blue Oval Lounge	7	03-04-2004 12:12 AM
MAF and e.t. ???'s	dragstang86	Windsor Power	4	11-18-2002 08:25 AM
Auburn posi ???'s...please help	dragstang86	Windsor Power	6	10-08-2002 05:52 PM
nitrous ???'s	dragstang86	Windsor Power	0	09-25-2002 08:03 PM
Just tried Autocross, 1st time! Couple of ???'s	LOCASH	Corner Carvers Delight	2	01-21-2002 04:56 AM

10-13-2002, 01:16 PM	#1
jruppert Registered Member Join Date: Jul 2001 Location: Reed City Mi Posts: 106	I have a question in relation to the topic. I have a '94 GT with similar mods as the first guy. GT-40P heads (ported and polished), e-303 cam, edelbrock upper and lower, 70mm tbody, 77mm pro-m, 24lb injecters, tremec tko, 3.73 gears, and recently added underdrive pullies. Anyway, not too long ago my Pro-M took a dump on me. It started making the cats run extremely hot and started smoking. I ran codes and said that my MAF was running below expected min. voltage. I sent the MAF back to have them take a look at it and possible recal. At the time I bought this MAF I didnt realize that you could use the C&L and change the sample tube. So what do u guys think?? If Pro-M comes back and says that I need to replace the sensor at my cost should I do so or should I just invest in a C&L with the sample tube for 24lb. Pro-M claims that if its their fault, they will take care of it. Now I know they claim this but you know how it is, its never their fault. I am not sure what they will charge for the repair but from what I understand you can buy a new C&L for $190 or so. Let me know what you guys think.