Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-15-2002, 01:25 PM
|
#4 |
|
Registered Member
Join Date: Sep 2002
Location: Macomb IL
Posts: 42
|
Well ive been looking around and pretty much all the 331 rotating assemblies say to use a 28oz offset flywheel. So i guess i will go for 28, its going to cost me a lot more to go 0 ballance and get a ballancer for an internally ballanced ford engine.
Just a street car project anyway. THanks for the help.
__________________
94 GT (Full length headers, Off Road H Pipe and Flowmasters) MSD Ignition, 75 shot nitrous, cold air induction. 65mm t.b. pulleys and 3:73 gears. everything else STOCK!! 60' = 2.04; 1/4 = 13.9 on street tires dynoed with 87 octane at 240hp 310 lb torch w/out nitrous. Its a pooch but im working on it. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| is the analizer flywheel or rearwheel horepower?? | superduty | Blue Oval Lounge | 5 | 08-02-2004 08:52 AM |
| Fidanza Flywheel Dowel Pins | RICKYRM125CC | Windsor Power | 0 | 10-27-2002 07:42 PM |
| Aluminum Flywheel Help | buck95 | Windsor Power | 6 | 12-02-2001 07:29 AM |
| Flywheel | Phantom5oh | Windsor Power | 15 | 09-26-2001 04:44 PM |
| clutch disc sticks to flywheel | GMSMOKER | Classic Mustangs | 3 | 08-13-2000 02:38 PM |