Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-22-2002, 06:15 PM
|
#4 |
|
Registered Member
Join Date: Oct 2001
Location: Madelia,MN USA
Posts: 58
|
O-ya about the compression thing I have to take that out of my sig. I wanted to go N/A then switched to boost I went with dished JE pistons 8.5:1. My goal for the car is to have my Cobra run high 10's low 11's at the track and be semi streetable. I switch alot of parts on and off for race/street. Suspension shocks,springs,gears, Eric you brought up a good point If I want to dump the clutch at 5,500 with slicks I suppose the torque of the launch puts alot of extra stress on the blocks main caps and stuff. Do you think the R-block is streetable. I'm thinking of going with a blueprinted sportsman block from Keith Craft, DSS girdle and keep my boost to 9psi max. Maybe I can lighten the car for more speed!
__________________
331 stroker, JE 8.5:1 pistons, H-beam rods, steel crank, main cap, msd with 3step, BBK ceramic long tubes,TKO, 4.30's, motorsport Z303, Victor Jr aluminum heads, crane gold 1.6, southside lift bars, 90/10 front, 50/50 rear, centerforce dual friction clutch, Vortech S-trim soon. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rare Mustangs....Got One? | 1969Mach1 | Blue Oval Lounge | 22 | 09-25-2010 04:59 AM |
| Engine Block Casting #s | CHRIS75 | Windsor Power | 24 | 05-31-2004 04:03 PM |
| Engine Block | schizcat | Windsor Power | 3 | 11-09-2003 12:38 AM |
| 5.0 Engine Block thoughts | squid | Windsor Power | 7 | 12-03-2002 08:05 AM |
| Will the 5.0 become obsolete | vetteeatr | Blue Oval Lounge | 36 | 07-11-2002 08:39 PM |