Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-24-2002, 07:24 PM
|
#2 |
|
Registered Member
Join Date: Oct 2001
Location: Florida Keys
Posts: 593
|
You have to find the hot and ground wires coming out of the sensor and check the voltage. A digital one works best in my opinion. There are two screws holding the sensor in place, there is one that you can loosen a little bit, and the sensor will rotate. Only loosen this screw a little bit and move it slightly. Check your voltage as you adjust it, and set it to .98 volts. Sometimes its a pain to keep it there, mine liked to jump a little as I was tightening it. Good luck - John
__________________
89 notch-finally not stock!! ported gt40's, ported cobra intake, 65mm tb, 75mm maf, mac cai, lt's,prochamber, fms 1.6 rr, 125 shot. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can you fix a squeaking throw out bearing? | ksteak | Windsor Power | 1 | 10-11-2001 04:55 PM |
| is it the throw out bearing? | DemonGT | Windsor Power | 2 | 06-20-2001 03:40 PM |
| will steeda tri-ax handle fit on my hurst short throw shifter? | SHaFT7 | Windsor Power | 1 | 06-10-2001 03:10 PM |
| Short throw shifter | swtstang | Windsor Power | 5 | 05-22-2001 01:40 PM |
| Short throw shifters | fazali | Blue Oval Lounge | 6 | 01-04-2001 12:32 PM |